T3400, T3400CT
3.22.2 Accessing the SETUP Program
Select 0 from the DIAGNOSTICS MENU and press Enter to display the following:
↑
↓
→
←
: Select items, Space, BkSp : Change values
Esc: Exit without saving, Home: Set default values, End: Save changes and Exit
NOTE: LCD Gray Scale Level does not appear on the T3400CT screen. Power On
Display does not appear on the T3400. Panel Power On/Off appears when either
computer is in Resume mode.
Moving Within the SETUP Menu and Changing Values
1. Press ← and → to move between columns. Press ↑ and ↓ to move between items
in a column.
2. Press the spacebar or BkSp to change the value.
Accepting Changes and Exiting the SETUP Window
1. Press End to accept the changes made.
If the changed item does not require a system re-boot, the following message is
displayed:
Are you sure? (Y/N)
If the changed item requires a system re-boot, the following message is displayed:
Are you sure? (Y/N)
Changes made will cause the system to re-boot.
2. To make other changes, press N. Repeat the steps above.
Capacity = ***MBTotal = 4096 KB
Base = 640 KB
Extended = 3328 KB
Shadow BIOS ROM = 128 KB
Not Registered
T3400 SETUP
POWER ON PASSWORD
HARD DISK
Power-up Mode = Resume
CPU Cache = Enabled
Processing Speed = High
Battery Save Mode = Full Power
Speaker Volume = High
Panel Power On/Off = Enabled
Alarm Power On = Disabled
Boot Priority = Enabled
Pointing Devices = Simultaneous
Hotkey = Enabled
Ext. Keyboard "Fn" key equivalent
= Disabled
COM/PCMCIA/FDD/PRT
Display Adapter = VGA compatible
LCD Display Mode = Color
LCD Gray Scale Level = Normal 64 Levels
Power On Display = Internal/External
DISPLAY
MEMORY
Serial Port = COM1(IRQ4/3F8H)
PC Card Slot = PCMCIA
Ext.FDD/PRT = Printer
Printer Port Type = Output
BIOS version = x.xx
OTHERS
To Next Page
Loading...
