T3400, T3400CT
2. Good track FORMAT
If a good track has been erroneously formatted as a bad track, use this subtest to
reformat it as a good track. Enter the drive, interleave, cylinder, and head numbers
as indicated in the screen prompt shown below.
Drive number select (1:#1, 2:#2) ?
Interleave number (1 / 1 - 8) ?
Press [Cylinder number (dddd)] ?
Press [Head number (dd)] ?
Press Enter to return to the Hard Disk Format menu.
3. Bad track FORMAT
To format a track as a bad track, enter the drive, interleave, cylinder, and head
numbers as indicated in the screen prompt shown below.
Drive number select (1:#1, 2:#2) ?
Interleave number (1 / 1 - 8) ?
Press [Cylinder number (dddd)] ?
Press [Head number (dd)] ?
Press Enter to return to the Hard Disk Format menu.
4. Bad track CHECK
This subtest reads the entire disk and displays a bad track list. The test is termi-
nated in case of a bad track check error. To initiate the subtest, enter the drive
number at the prompt shown below.
Drive number select (1:#1, 2:#2) ?
Bad tracks are displayed in the format shown below.
[[cylinder, head = 0123 03]]
Press Enter to return to the Hard Disk Format menu.
NOTE: After the HDD has been formatted, execute the Toshiba MS-DOS FDISK
command to partition the HDD. Next, execute the Toshiba MS-DOS FORMAT com-
mand. Refer to the Toshiba MS-DOS manual for more information about using these
commands.
To Next Page
Loading...
