Toshiba T3400CT - Power Supply Board Installation Steps

4-24
T3400, T3400CT
4. Disconnect the power supply/system joint board from the power supply board
(Figure 4-18).
Figure 4-18 Removing the Joint Board
Installation
To install the power supply board, follow the steps below and refer to Figures 4-17 and 4-18.
1. Connect the power supply/system joint board to the power supply board (Figure
4-18).
2. Seat the power supply board into the bottom cover, being careful to clear the
plastic light conductor for the battery LED indicator (Figure 4-17).
3. Replace the system board, AccuPoint control button, RTC and backup batteries,
hard disk drive, top cover, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.9 through 4.2.