T3400, T3400CT
Installation
To install the monochrome display module, follow the steps below and refer to Figures 4-24
through 4-26.
1. Connect the flat cable to the display cable (Figure 4-26).
2. Connect the flat cable to the display unit (Figure 4-25).
3. Seat the display module in the display cover and secure four brass M2x6 screws,
one at each corner (Figure 4-24).
NOTE: Secure the ground cable at the bottom right corner with one of the screws.
4. Replace the FL inverter board, display mask, and battery pack as described in
sections 4.14, 4.13, and 4.2.
To Next Page
Loading...
