44
Advanced MENU
Overscan
Adjust overscan ratio of the image.
Press
. Adjust with / [ - ] (Lower) or / [ + ] (Higher) key.
No overscan when set to 100%
NTSC mode
Set the black level for Video/S-video input.
Press
. Select US(7.5IRE)/Japan(0IRE) with / [UP] [DOWN] key.
This can be adjusted only when video input source is Video/S-video and input signal is
NTSC or NTSC4.43.
HDMI mode
Set the black/white level for HDMI input.
Press
. Select HDMI/DVI with / [UP] [DOWN] key.
This can be adjusted when input source is HDMI.
Frequency
Adjust the sampling frequency to eliminate periodic patterns and fl ickering when many
vertical lines appear on the screen.
Press
. Adjust with / [ - ] or / [ + ] key.
This can be adjusted when input source is Computer.
Phase
Adjust the sampling phase to eliminate fl icker.
Press
. Adjust with / [ - ] or / [ + ] key.
This can be adjusted when input source is Computer.
MPEG NR
Adjust the detail of noise reduction. Mpeg noise reduction level.
Press
. Adjust with / [ - ] (Lower) or / [ + ] (Higher) key.
Reset
Reset Advanced picture setting MENU adjustments and settings to factory default.
Press
. Confi rmation window will appear and select [Yes] with / [ - ] or / [ + ] key
and press
to reset.
Using menus (Continued)
To Next Page
Loading...
