Toshiba TDP-ET10 - POWER SUPPLY CORD SELECTION; IMPORTANT PRECAUTIONS; Location and Installation Guidelines

9
Before Using
POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable.
Plug
confi guration Plug type
Line
voltage
Plug
confi guration Plug type
Line
voltage
EURO 220 - 240V Australian
240V
10A
220 - 240V
UK 220 - 240V Switzerland
240V
6A
220 - 240V
Use a 5A fuse which is approved by
ASTA or BSI to BSI362.
Always replace the fuse cover after
changing the fuse.
North American
240V
15A
220 - 240V
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to
ship your projector. For maximum protection, repack the set as it was originally packed at
the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm loca-
tion. When the unit is exposed to such a change in temperature, moisture may condense
on the crucial internal parts. To prevent the unit from possible damage, do not use the
unit for at least 2 hours when there is an extreme or sudden change in temperature.
Location and Installation
• Do not place in hot locations, such as near a heater or in direct sunlight. Doing so could
cause malfunction, and shorten the life of the projector.
• Avoid locations with oil or cigarette smoke, which can affect the quality and useful like of
the product optical parts and darken the screen.
• Do not use the product vertically in any upright position or slantwise in an angle of 20
degrees or more.
• Using this instrument near a TV or radio may cause interference to the images or sound.
If this happens, move it away from the TV or radio.
• In a high altitude location where air is thin, cooling effi ciency is reduced so use it with the
ambient temperature being lowered.
• The set of projector is hot after use. Handle with care.
• Do not use the projector while holding it in your hands or lap.
• Do not use the projector near a power source and the like, or in locations like a ship
or vehicle that are subject to vibration or shock. Doing so may lead to a malfunction or
shorten service life.