User’s Manual
7-4
HW S
ETUP
AND
P
ASSWORDS
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
4. Follow the same procedures described in the earlier section, How to set the
password, to set a new user password.
Parallel/Printer
This tab lets you set the Printer Port Type. Use the Windows Device Manager to
make settings for the Parallel port.
Parallel Port Mode
The options in this tab are
ECP
and
Standard Bi-directional
.
Display
This tab lets you customize your computer’s display settings for either the inter-
nal LCD screen or for an external monitor.
Power On Display
Lets you set the display to be used when the computer is booted.
ECP
Sets the port type to Extended Capabilities Port (ECP).
For most printers, the port should be set to
ECP
. (Default)
Standard
Bi-directional
This setting should be used with some other parallel
devices.
Auto-Selected
Selects an external monitor if one is connected. Other-
wise, it selects the internal LCD. (Default)
LCD+AnalogRGB
Selects both the internal LCD and external monitor for
simultaneous display.
To Next Page
Loading...
