1-13
3-8. MULTI-PBS (Polarizing Beam Splitter)
Step Figure Explanation
1 Remove 1 screw (M3 x 6).
Screw: type [M-1]
2 Remove 2 screws (M2.5 x 8SW).
Screw: type [E-1]
3 After pulling out the fitting spring from the gap between
Multi-PBS and frame, remove the Multi-PBS.
[Note]
When installing, make sure of the direction of the Multi-
PBS (Lamp side and prism side).
Prism side
To Next Page
Loading...
