8
E6582171
Install the Resolver option to the inverter according to the procedures below.
2.1 Installation to the Inverter
■ Mounting
■Removing
2. Installation and wiring
Insert the option straightly
and slowly so that it fixes with
the guide inside option slot.
Insert the option into the slot B.
Keep the option from hitting other parts near slot.
1)
The option should be inserted until
the body is totally covered by the slot.
(Refer to the picture above)
2)
Remove the option in the direction of arrow while
pushing the "PUSH" tab by a screw driver.
1)
To Next Page
Loading...
