E6581611
F-7
6
Table of parameters that can be changed using the guidance function
Prese
speed setting
auf=2
Motor 1&2 switching operation
auf=4
Motor constant setting guidance
auf=5
6.1.4 Automatically adjusting acceleration/deceleration time
au1 : Automatic acceleration/deceleration
Function
This automatically adjusts acceleration and deceleration time in line with load.
Refer to section 5.2 for setting acceleration/ deceleration time manually.
=
* Adjusts the acceleration/deceleration time automatically within the range of 1/8 to 8 times as long as the
time set with the or , depending on the current rating of the inverter.
=
* Automatically adjusts speed during acceleration only. During deceleration, speed is not adjusted
automatically but reduced at the rate set with .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General