E6581611
G-1
7
7. Operations with external signal
7.1 Operating external signals
You can control the inverter externally.
The parameter settings differ depending upon your method of operation. Determine your method of operation (the
operational signal input method, speed (frequency) command input method) before using the procedure below to
set the parameters.
[Procedure for setting parameters]
With run/stop from the Panel keypad
= (Panel keypad)
* For settings based on communication, refer to the Communication Manual (E6581913) or section 6.38.
Check external signal conditions
With speed (frequency) command from panel keypad
= (setting dial 1)
= (setting dial 2)
With speed (frequency) command from external signal
= (terminal VIA)
(terminal VIB)
(UP/DOWN from external
logic input)
8 (Terminal VIC)
11 (Pulse train input)
4, 6, 7 (Communication)
Run signal:
Panel keypad
Speed command:
Panel ke
ad
Refer to section 3.3
Example 1), 2)
Run signal:
Panel keypad
Speed command:
Terminal
Run signal:
Terminal
Speed command:
Panel ke
ad
Run signal:
Terminal
Speed command:
Terminal
With run/stop from external signal
= (terminal block) *
, ,
(communication)
*
Refer to section 3.3
Example 3)
Refer to section 3.3
Example 4)
+
RUN
STOP
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General