Toshiba TOSVERT VFS15-4037PL-W User Manual

E6581611
G-10
7
 List of output terminal function settings
List of detection levels for output terminal selection
Parameter
programmed value
Function
Parameter
programmed value
Function
Positive
logic
Negative
logic
Positive
logic
Negative
logic
Frequency lower limit    Heavy load output
Frequency upper limit    Lower limit frequency stop
Low-speed detection signal    Power failure synchronized operation
Output frequency attainment signal
(acceleration/deceleration completed)
   Traverse in progress
Set frequency attainment signal     Traverse deceleration in progress
    Fault signal (trip output)    Parts replacement alarm
    Over-current detection pre-alarm     Over-torque detection pre-alarm
    Overload detection pre-alarm     Frequency setting mode selection 1/2
    Overheat detection pre-alarm     Panel / remote selection
    Overvoltage detection pre-alarm    Forced continuous operation in progress
    Power circuit undervoltage detection    Specified frequency operation in progress
    Small current detection     Signal in accordance of frequency
command
    Over-torque detection     Fault signal (output also at a retry waiting)
    Braking resistor overload pre-alarm    PTC input alarm signal
    Run/Stop     Factory specific coefficient *1
    Serious failure     Analog input break detection alarm
    Light failure   F terminal status
    Cooling fan ON/OFF   R terminal status
    In jogging operation     Cooling fan replacement alarm
    Operation panel / terminal block
operation
   Number of starting alarm
    Cumulative operation time alarm    Acceleration operation in progress
    Communication option
communication error
   Deceleration operation in progress
    Forward/reverse run     Constant speed operation in progress
    Ready for operation 1    DC braking in progress
    Ready for operation 2 to  Factory specific coefficient *1
    Brake release 180 181 Integral input power pulse output signal
    Pre-alarm 182 183 Shock monitoring pre-alarm signal
    RS485 communication error to  Factory specific coefficient *1
    Designated data output 1  Always OFF
    Designated data output 2  Always ON
  Light load output 
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
<Explanation of terminology>
 Alarm …... Alarm output when a setting has been exceeded.
 Pre-alarm …... Alarm output when the inverter may cause a trip during continued operation.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net

Toshiba TOSVERT VFS15-4037PL-W Specifications

General

Brand	Toshiba
Model	TOSVERT VFS15-4037PL-W
Category	Inverter
Language	English