Toshiba V Series - Chapter 3 Preparations for Operation (Hardware)

6F8C0942 27
4.3 Installation and Wiring of Relay Connector Unit
4
4.3 Installation and Wiring of Relay Connector Unit
Fasten the relay connector unit to the cabinet. Observe the allowable cable bending
radius requirements, and clamp the cables after connection.
Connect the inside cubicle cable (UTP cable) from a TC-net 100 module or hub unit to
one side of the relay connector unit, and the outside cubicle cable (STP cable) from other
station to the other side of the unit.
Figure 4-12 Connecting Cables to Relay Connector Unit
To TC-net 100 module
Inside cable (UTP cable)
Outside cable
(STP cable)
To other station