Tosok CAG2000 - Managing Mastering Data; 7.2 Clearing Mastering Data

15
7.2 Clearing mastering data
 In the measure mode, press for 2 sec or more.
 When the MAS LED below the bargraph display is turned on and “MAX M.” or
“MIN M.” is shown on the alphanumeric display (refer to Fig. 7-1), press to
change to the adjust detector mode and show “ADJ.” on the alphanumeric display.
 Press to change to the clear mastering data mode and show “MAST CLS”
on the alphanumeric display.
 Press to clear the mastering data, show “M. CLS OK” on the alphanumeric
display, and return to the master mode.
Fig. 7-5. Clearing mastering data.
2
1
3
SET
MAS
ENT
RST
SET MAS
2
1
3
SET
MAS
ENT
RST
SET MAS
ADJ.
Press
2
1
3
SET
MAS
ENT
RST
SET MAS
MAST CLS
Press
M .CLS OK