20
Press to determine the selected measuring range. The next step is setting
the shift value, and “SHIFT” is shown on the alphanumeric display.
Fig. 9-5. Determining measuring range.
(3) Setting shift value
In the case of a one-side tolerance, for example, the measured value is shown at the
center of the bargraph display. When not using this function, set the shift value at 0.
With “SHIFT” shown on the alphanumeric display, press . The current
notation unit is shown. Press or to change to the tolerance notation
in µm or the nominal notation in mm. Press to determine the selected
notation.
Fig. 9-6. Changing notation unit.
2
1
3
SET
MAS
ENT
RST
SET MAS
100
Determines
measuring range
2
1
3
SET
MAS
ENT
RST
SET MAS
SHIFT
2
1
3
SET
MAS
ENT
RST
SET MAS
SHIFT
Press
2
1
3
SET
MAS
ENT
RST
SET MAS
MM
Changes
notation unit
Changes
notation unit
2
1
3
SET
MAS
ENT
RST
SET MAS
MICRO
Determines
notation unit
To Next Page
Loading...