02
Electrical Safety Warning
● All wiring must be complied with local and national electrical codes. All wiring
must be installed by qualified electricians. If you have any questions about the
instructions, contact a qualified electrician.
● Make sure the power supply is cut off you until finish installing the air conditioner.
Otherwise, it may cause an electric shock.
● Check the available power supply and resolve any wiring problems before
installing and operating this unit.
● This air conditioner is designed to operate from a 115V AC, 60Hz, 1 Phase
power supply.
● Air switch should include magnet buckle and heating buckle function to can
protect the circuit from short and overloading.
● An all-pole disconnection switch having a contact separation of at least 3mm in
all poles should be connected in the fixed wiring.
● Electrical wiring may be present between roof and ceiling. Be sure that power is
disconnected at the mains and battery.
FCC Information
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
This device complies with part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interference.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
To Next Page
Loading...
Need help?
General
