DC Inverter U-match Series for R410A Unitary Split Air Conditioner
4 Maintenance
4.1 Failures Not Caused by Faults of The AC
(1) If your air conditioner fails to function normally, please first check the
following items before maintenance:
The air
conditioner can't
run.
If you turn off the unit and
then immediately turn it on, in
order to protect the
compressor and avoid
system overload,
compressor will delay
Please wait for a while.
Wire connection is wrong.
Connect wires according to
Fuse or circuit breaker is
Replace the fuse or switch on
Power failure.
Restart after power is
Power plug is loose. Re-insert the power plug.
Bad cooling or
heating effect.
Air inlet and outlet of the
units have been blocked.
Clear the obstacles and keep
the room for the units well
Improper temperature setting Reset a proper temperature.
Fan speed is too low. Reset a proper fan speed.
Air flow direction is not right.
Change the direction of air
Doors or windows are open. Close them.
Exposed under direct
Put on curtains or louvers in
Too many heat sources in the
Remove unnecessary heat
Filter is blocked or dirty.
Send for a professional to
Air inlets or outlets of the
units are blocked.
Clear away obstacles that are
blocking the air inlets and