10
General Instructions for Use
Power supply
The power supply cord contains a current device that senses damage to the power cord. To test
your power supply cord, do the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST button, you will
notice a click as the RESET button pops up.
3. Press the RESET button, again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products this is also
indicated by a light on the plug head.)
NOTICE:
• Do not use this device to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
• The power supply must be replaced if it fails reset when either the TEST button is pushed, or it
cannot be reset. Please contact customer service.
• If power supply cord is damaged, it cannot be repaired. It MUST be replaced with a new cord.
Please contact customer service.
NOTE: The power cord of window type unit has creepage
protection device.
There is a test button and a reset button on the plug. You
are suggested to check the power cord periodically.
Check method: After putting through the power, the in-
dicator is ON. After pressing the TEST button, the indicator
is OFF and you can hear a sound. Then press the RESET
button, the indicator will be ON, which indicates the pro-
tection device is normal.
NOTE: Plug may be different with the actual product.
Please refer to actual product.
Operating temperature range
Indoor side DB/WB (°C/°F) Outdoor side DB/WB (°C/°F)
Maximum Cooling 40°C (104°F) / 26.7°C (80°F) 40°C (104°F) / 26.7°C (80°F)
The operating temperature range (outdoor temperature) for cooling unit only is 18°C to 40°C
(64.4°F to 104°F).
LCDI
POWER
RESET
TEST
RESET
TEST
Indicator
Indicator
To Next Page
Loading...
Need help?
General
