EasyManua.ls Logo

TOTALINE P474-0140 - Switch Issues & AC Not Cooling; Fan & Aux Heat Not Operating

TOTALINE P474-0140
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 19
OWNER'S MANUAL
MODEL P474-0140
72
TOTALINE
Heat
Off
Cool
Fan On
FanA uto
72
TOTALINE
Heat
Off
Cool
Fan On
FanA uto
TroubleShooting
72
TOTALINE
Heat
Off
Cool
Fan On
FanA uto
SYMPTOM: The Air Conditioning does not
attempt to turn on.
CAUSE: The cooling setpoint is set too
high, the Mode Switch is not set for
Cool, the batteries are too weak, or the
Aux. Heat Switch is set for Emergency.
REMEDY: Consult the Normal Operation
section in this manual to:
Lower the cooling setpoint (Page 6)
Correct the Mode Switch position (Page 6)
Replace the batteries (Page 10)
Adjust the Aux Switch to Normal (page 7)
SYMPTOM: The slide switches on the thermostat
are very difficult to move.
CAUSE: The backplate of the thermostat is
screwed too tightly into a wall that is not
perfectly flat.
REMEDY: Loosen the screws holding the
thermostat into the wall.
SYMPTOM: The fan does not turn on even though
the compressor has energized.
CAUSE: The Fan Switch is not completely in the
On or Auto position.
REMEDY: Slide the Fan Switch firmly into the On
or Auto position.

Related product manuals