Tower Hobbies T16013 - Troubleshooting

26
PROBLEM REASON SOLUTION
1 Difcult to close the lid
Sealing ring not installed
properly
Position the sealing ring
correctly
The oater valve clamps the
push rod
Lightly push the push rod
2 Lid difcult to open
Float valve in the popped-up
position
Press the oat valve
lightly with a utensil
Pressure exists in the cooker
(caution)
Open the lid after the
pressure is COMPLETELY
released
3 Steam leaks from the lid
Sealing ring not installed
properly
Install the sealing ring
correctly
Food debris attached to the
sealing ring
Clean the sealing ring
Sealing ring damaged Replace the sealing ring
The lid is not closed properly Close the lid correctly
4 Steam leaks from oat valve
Food debris on the oat valve
gasket
Clean the sealing ring
Sealing ring damaged Replace the sealing ring
5 Float valve unable to rise
Too little food and water in the
inner pot
Add water and food
according to the recipe
Steam leaks from the lid or
exhaust valve
Contact the service
centre for repair
6
Steam comes out from
exhaust valve non-stop
Exhaust valve not in sealing
position
Turn exhaust valve to
sealing position
Pressure control fails
Contact the service
centre for repair
7
Power indicator does not
light
Bad contact in power socket
Please check the power
socket
8
Rice half cooked or too
hard
Too little water
Add more water
accordingly
Lid opened prematurely
After cooking cycle
completes leave the lid
on for 5 more minutes
7 - Troubleshooting