TOYAN
47
When the nitro content of the fuel increases or the fuel brand changes, it is recommended to run the engine with a rich needle
adjustment so that the optimum settings for the new fuel can be rechecked. (Please adjust the ratio of gasoline and fuel in the
range of 1:25 to 1:30, and use 2T internal combustion engine oil as the oil).
remind!
Glow plugs don't last long when the engine is running at very high speeds and on high nitro fuels. Note again that model engine
fuel is toxic. Do not let it come into contact with eyes or mouth. Always store it in a clearly marked container out of the reach of
children. It is also highly flammable and must be kept away from open flames, overheating or any possible ignition source.
3.fuel tank:
It is recommended to use a fuel tank with a capacity of 100cc. Please keep the fuel tank installed on the same plane as the
engine. The drop between the fuel output port of the fuel tank and the fuel input port of the carburetor should be kept within
1cm (only the carburetor can be higher than the fuel output port of the fuel tank). A high drop will reduce the working
efficiency of the carburetor and have an adverse effect on starting the engine. In order to ensure clean fuel supply, please use
standard 5mm silicone oil pipe and install the oil filter correctly. Since the engine itself relies on negative pressure to absorb oil
, it is recommended to use the muffler exhaust pipe pressurized oil nozzle to provide pressure to the fuel tank).
4. Start the power supply:
X-Power needs to purchase a standard 7.4V25C lithium battery, which can be started quickly after being connected. A
starting battery with too low or too high voltage will not guarantee the service life of the starting motor.
To Next Page
Loading...
