Toyota 2012 CAMRY LE - Main Harness Routing and Connection

TOYOTA CAMRY LE / SE / XLE 2012- DUAL SEAT HEATER KIT
Section II –Installation
Page 4 of 8
Form #5386, Rev. B, 07-11-2014
Install Main Harnesses
1. Remove the shift knob bezel / cup holders,
and center floor console.
2. Install the driver (red tape) and passenger
(blue tape) main power harnesses near the
factory floor harness as shown. Figure 7
3. Route the outputs for the driver (red) and
passenger (blue) side seat elements to the
opening in the carpet underneath the seat near
the air vent. Figure 8
4. Route the inputs for the driver (red) and
passenger (blue) side switches to the area in
front of the shift knob and set aside. Figure 9
5. Route and connect the two ground terminal
rings to ground point I3 below the HVAC
controls. Figure 10
6. Remove left door step, kick panel, and lower
instrument panel.
7. Route the inputs for the driver and passenger
power (red and blue wires) to the center
console beneath the radio, and left behind the
driver knee panel to the driver side junction
box. Figure 11
8. Disconnect connector 3C from the junction
box, and release the locking tabs on the
connector. Insert the red wire (driver side
power) into Pin 4 of connector 3C. Insert the
blue wire (passenger side power) into Pin 13
of connector 3C. Replace the locking tabs on
the connector and reconnect the connector to
the Junction Box. Figure 12a
Figure 7
Figure 10 Figure 11
Ground
I3
Wire
Ties
Wire
Ties
Figure 9
Figure 8
NOTE: For XLE models, take care to route
the relays and main harnesses beneath the
HVAC ducting at the right of the shifter
bl
Camry LE / SE