4
CALLING BY VOICE RECOGNITION
After the beep say, “Dial <number>.”
Say the phone number digits
individually, without pausing (e.g. “Dial
Three, one, zero, four…”).
step
2
step
3
Press on the steering wheel. After
the beep say, “Use the Phone.”
step
1
After the beep, say “Dial” or press
on the steering wheel.
Call is active when
is
indicated. To end call, press
on the screen or
on the steering
wheel.
step
4
Quick Tip - It is recommended that you reduce
background noise prior to using the Voice
Recognition system. Conversation, high fan speed,
wind noise (open windows), etc., may prevent the
voice recognition system from understanding your
commands.
Quick Tip - If you know your next command, you
can press
at any time to interrupt the prompt.
Speak your command after the beep.
Some Bluetooth
®
equipped cell
phones may or may not show battery or signal strength
on the display.
DIAL BY NUMBER
Quick Tip - You can skip Step 1 and say Dial
commands immediately from the Shortcut Menu.
To Next Page
Loading...
Need help?
General
