ST-6
STARTING SYSTEM
-
Pre-Heating System (Super Glow Type
[2L-TI
)
2.
INSPECT RELAY OPERATION
(a)
Apply battery voltage across terminals e and g.
(b)
Using an ohmmeter, check that there
is
continuity
between terminals B and G.
If operation
is
not as specified, replace the relay.
Glow
Plug
INSPECT GLOW PLUG
Using an ohmmeter, check that there
is
continuity be-
tween the glow plug terminal and ground.
If there
is
no continuity, replace the glow plug.
HINT:
Be careful not to damage the glow plug pipes
as
it
could
cause an open circuit or shorten life of the plugs.
Avoid getting oil and gasoline on the glow plug when
cleaning.
During inspection, be sure to wipe any oil off the glow
plug terminal and bakelite washer with
a
dry cloth.
Be careful to apply more than
11
volts to the glow plug
as
it
could cause an open circuit.
Glow
Plug
Resistor
INSPECT GLOW PLUG RESISTOR
Using an ohmmeter, check that there
is
continuity be-
tween the resistor terminals.
If there
is
no continuity, replace the resistor.
To Next Page
Loading...
Need help?
General
