6. Getting started
Once your hands-free system is professionally installed, use these procedures to get
started.
6.1. Set your language
ò Caution: When you change your hands-free system’s language, all contacts in your
Contacts list and devices in your Device list are deleted.
1 Turn o the vehicle ignition and wait for 15 seconds.
2 Press and hold the Seek down and Mode button at the same time, turn on the vehicle
ignition, and continue holding the Seek down and Mode button and wait till the
hands-free system enters language selection and responds: Language Menu. Press
volume up or down to change language.
3 Press the Volume Up and Volume Down buttons to scroll through the language
choices.
As you scroll to a language, the hands-free system plays the prompt for that
language. (For example: American English. To choose this language, restart the vehicle.)
4 When you have selected the desired language, turn o the vehicle ignition and wait
for 15 seconds.
5 Turn on the vehicle ignition.
6.2. Connect your device to the hands-
free system
Before you can make a hands-free call or stream music*, you must establish a Bluetooth®
connection between your Bluetooth® device and the hands-free system with a paired
link.
When you set up a paired link, the hands-free system remembers your device. Once the
hands-free system and device are paired, your hands-free system automatically connects
to your device every time you start your vehicle.
This hands-free system supports paired links with up to 4 devices.
m
Warning: For safety reasons, it is recommended that pairing be done while the
vehicle is stationary.
* On some models.
To Next Page
Loading...
