10.4. Pair to a device
1 Your device’s Bluetooth® feature is o by default. To use your car hands-free system,
you must rst turn on the Bluetooth® feature in your device. See your device’s user
manual.
2 Press and hold the Mode button.
The system responds: Phone/Setup menu. {Say a command}.
3 Say Pair Device.
The system responds: Set your device in search mode and enter 0000 if prompted for the
passcode.
4 Perform a device discovery from the device (See your device’s user manual). Your
device searches for any Bluetooth® devices around it. When the search is complete, it
displays a list of the devices it nds. Searching may take a minute or two to complete.
5 Select TOYOTA from the list of devices.
6 At the handset device, if prompted, enter the passkey 0000 and press the OK key.
The system responds: Pairing complete. Please say a friendly name for the device.
7 Say a friendly device name for your device. For example, you can say “Jenny’s Phone”.
The system responds: <device name> added.
8 At the handset device, if prompted to accept the Bluetooth® link, enter Yes.
After a few seconds, the system responds: Connection complete. Your hands-free
system is now ready to make and receive calls and/or stream music.*
10.5. Connect a paired device
1 Press and hold the Mode button.
The system responds: Phone/Setup menu. {Say a command}.
2 Say Connect <device name>, where <device name> is the friendly name for the device
you want to connect. For example ‘Connect Jenny’s Phone’.
The system responds: Connecting <device name>.
Upon successful completion, the system responds: Connection complete.
* On some models.
To Next Page
Loading...
