30. Check clearance of tonneau cover to vehicle rear corners. Ensure the tailgate is open and close tonneau cover.
Check clearances at both rear corners between tonneau cover and sheet metal. Gaps should be consistent. If tonneau
cover is touching sheet metal or gaps are not even, adjustment of the tonneau position may be required. Refer to the
Tonneau Cover Position Adjustment and Latch Position Adjustment section of this fitting instruction for more
information.
Note: If there is no adjustment required, torque all hinges and latches to 5Nm.
GAP
Page 14 of 34Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c
Diagram #30
29.
NOTE: Two people are required to carry out fitment of the Tonneau Cover. Carefully lift and fit the tonneau cover to
the vehicle. Ensure the hinges sit correctly in the header rail and that the tonneau flap/header rail seals are sitting
correctly (check that they are not pushed out of alignment or being pinched by the lid). Note: header rail seal should sit in
the slot cutout in the infill panel. Secure the tonneau hinges with hinge pins (8) hooked into header bar (4).
See Dia #29.
8
8
1
4
Diagram #29
32
Diagram #:28
28. Secure the infill panels with a scrivet (32) on each side. See Dia #28.
A-DECK SECTION VIEW
FLAP SEAL
HEADER-RAIL
SEAL
FRONT
To Next Page
Loading...
