Toyota HILUX ‘A’ DECK - Removal of Tonneau Cover; Replacement of Tonneau Cover

2
REPLACEMENT OF TONNEAU COVER
2. Attach gas struts (2) by clipping into place. Ensure
narrow end (1) mounts to the vehicle. Reconnect the
6-way connector located in the front/LH tonneau area.
Refit the tie clip to the bracket. Refer to figure 6.
1.
Fit tonneau cover (2) and secure hinges with hinge pins
(1). Refer to figure 5.
NOTE: 2 people are required to lift and fit the tonneau
cover onto the vehicle.
FIGURE 4
FIGURE 5
FIGURE 6
REMOVAL OF TONNEAU COVER
1.
Open tonneau cover. Disconnect the 6-way connector
located in the front/LH tonneau area. Remove the tie clip.
from the bracket. Detach gas strut (1) by inserting a small
screwdriver and adjusting the spring clip (2) on the gas
strut (1). Refer to figure 2.
NOTE: Do not remove the spring clip. only a small
amount of levering is required to detach.
2.
Remove hinge pins (1) and remove tonneau cover (2).
Refer to figure 3.
NOTE: 2 people are required to lift and remove the
tonneau cover from the vehicle.
FIGURE 3
FIGURE 2
FIGURE 1
2
2
1
1
1
1
1
2
Page 31 of 34Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
1
1
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c