PARTS IN LOOM KIT
Tools Required:
• Pen / Marker
• Centre Punch
• Drill & drill bits; Ø3mm, Ø5.5mm, Ø6mm,
Ø7mm & Ø9mm
• Phillips Screwdriver
• Torque Wrench
• Trim removal Tools
• Step Drill Ø25mm, Ø35mm
• M8 Tap
• T40 & T50 Torx Bit
• Caulking Gun
• Silicon - Non Acetic
• Die Grinder & multi tool
• Masking Tape
• Scissors & Knife
• Ruler
• Wire Cutters
• Drill Stop
• 10mm,12mm,13mm & 14mm
Spanner & Socket
• Rivet Gun
• Tape Measure
• Soapy Water Solution
• Allen Key Set (Metric)
• 35mm Hole Saw
• Ratchet
• Jeweller’s Flat Head Screwdriver
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
Page 3 of 34
TC0403c
Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
Relay Harness x1
(locking variant only)
AB D
Extension Patch x1
C
Power Harness x1
1-Way
Female Connector x2
(locking variant only)
E
6-Way
Female Connector x1
6-Way Male Connector x1
(locking variant only)
F
Scotch Lock Housing x1
GH
J
Mini Blade Fuse - x17.5A
I
Cleaning Pad x2
Adhesive Cable Tie
Mounts x4
K
Cable Tie -
Lamp only variant x25
Locking variant x35
200mm
Cable Tie - 600mm x3
L
Ø8mm P-Clip x2
MN
M6 Flange Nut x1
(locking variant only)
O
Ø6mm P-Clip x1
P
7x12 Cable Tie Clips x2
CLEANING
PAD
To Next Page
Loading...
