The aerial panoramic image comes from the use of optical principle, where
intersection parts of four cameras are for image clipping process to build
panoramic effect, hence, four connection parts of images listed below would
cause image to temporarily disappear and drivers are requested to pay special
attention.
Objects may not be detected from some angles. The objects underneath the
bumper or on the ground may not be detected when they are displayed at front or
rear viewing angle (Grey parts in oblique lines).
The images from four cameras are in color difference under versified light
source due to light incoming angle discrepancies, which is normal.
The guide lines in the front left/right side of car mode are aligned due to
shooting position/angle difference from left/right rear mirrors; however, mild
staggered position of doors is normal.
PVM display area is constricted, where the further part from the car body will
present image deformation, which is normal.
PVM camera are precision device. Do not hit camera, which might cause
abnormal situations like failure or damage.
PVM is to aid and reinforce display of periphery blind areas against the car
body. When you drive, you still must make use of the left/right side mirrors and
rear view mirrors.
When you reverse, some conditions (Ex.: weather, light) might constrict
image. Do not drive your car only by the display.
PVM image might be affected or incorrect with the change of tire size; hence,
we do not suggest you to change tire size.
Heavy impact or displacement from collision might cause PVM image to
diverge right or left, worsening image connection. To resume normal
operations, image calibration and part replacement may be required.
COROLLA CROSS - MAR - 2021 - 001
Please read this manual for proper operation and keep it for future reference.
To Next Page
Loading...
