English
English
Owner’s Manual
35
Error
Display
Cause Measure
USB
Devices
DEVICE
ERROR
The connected USB device is not
supported.
If the USB device is frozen, disconnect it, and
reconnect it again.
Connect a proper USB device.
An error occurred when controlling the
USB device.
Disconnect the USB device, and reconnect it
again.
The device is connected via the USB
Hub.
Disconnect the device, and reconnect directly
to the USB connector of this unit without using
the USB Hub.
OVER
CURRENT
Over-current or data error is detected. Turn off the ignition switch, disconnect the
device, restart the engine and reconnect it
again. If the device is still not recognized, try
replacing with a different device.
BT
Audio
NO
BLUETOOTH
AUDIO
Advanced Audio Distribution Prole
(A2DP) is not connected to the unit.
Disconnect and reconnect the device to the
unit.
20. ERROR DISPLAY
To Next Page
Loading...
Need help?
General
