57
OVERVIEWELECTRIC VEHICLE SYSTEMFEATURES & OPERATIONSTOYOTA SAFETY SENSE
SAFETY &
EMERGENCY FEATURES
ADJUSTING DISTANCE
To change the vehicle-to-vehicle distance:
Press the “ ” switch to cycle
through the settings, which will change
progressively.
This mode employs a radar sensor to detect the presence of a preceding vehicle
up to approximately 328 ft (100 m) ahead, determines the current vehicle-to-vehicle
following distance and operates to maintain a preset following distance from the
vehicle ahead. These distances vary based on the vehicle speed.
Note: Vehicle-to-vehicle distance will close in when traveling on long downhill
slopes.
(1) (2) (3)
(1) Constant speed cruising when there are no vehicles ahead
The vehicle travels at the speed set by the driver. The desired vehicle-to-
vehicle distance can also be set by operating the vehicle-to-vehicle distance
control switch.
(2) Deceleration cruising and follow-up cruising when a preceding vehicle
driving slower than the set speed appears
When a slower vehicle is detected running ahead of you, the system
automatically decelerates your vehicle. When a greater reduction in vehicle
speed is necessary, the system may apply the brakes (the brake lights will
come on at this time). The system will respond to changes in the speed of the
vehicle ahead in order to maintain the vehicle-to-vehicle distance set by the
driver. A warning tone warns you when the system cannot decelerate sufficiently
to prevent your vehicle from closing in on the vehicle ahead.
Full-Speed Range Dynamic Radar Cruise
Control (DRCC)
lets you drive at a preset speed. The system is designed to function between
distance from the vehicle ahead of you.*
* See www.toyota.com/safety-sense for more information.
system operation may be limited.
Refer to page 58 for switching to Constant Speed (Cruise) Control Mode.
the vehicle in front changes lanes or speeds up.
(1) Press “
” to turn DRCC system ON. The “Radar Ready” and “
will come on.
(2) Use the steering wheel controls to increase speed by pressing “+RES” or
decrease the speed by pressing “-SET”. Press and hold to make a large
km/h [0.6 mph] increments).
(3) Press “Cancel” to cancel the speed control.
*
The speed control may also be canceled by depressing the brake pedal.
switch
switches
LONG
(default setting)
MIDDLE
SHORT
Preceding vehicle
mark
MY23_RAV4-PRIME_QRG_V2_ML_0907_PRINT.indd 57 9/13/22 11:46 AM
To Next Page
Loading...
