58
TOYOTA SAFETY SENSE
™
Automatic High Beams (AHB) safety system is designed to help the driver see
” switch.
”position.
” will come on when the headlights are on and the
h beams. Press the
to turn the AHB system off.
speed is approximately 21 mph (34 km/h) or more.
area ahead of the vehicle is dark.
are no oncoming or preceding vehicles with headlights or taillights turned
are few streetlights on the road ahead.
speed drops below approximately 17 mph (27 km/h).
area ahead of the vehicle is not dark.
or preceding vehicles have headlights or taillights turned on.
are many streetlights on the road ahead.
ADJUSTING DISTANCE (CONTINUED)
(3) Acceleration when there are no longer any preceding vehicles driving
slower than the set speed
The system accelerates until the set speed is reached. The system then
returns to constant speed cruising.
Note: When your vehicle is too close to a vehicle ahead, and sufficient
automatic deceleration via the cruise control is not possible, the display will
flash and the buzzer will sound to alert the driver. An example of this would be
if another driver cuts in front of you while you are following a vehicle. Depress
the brake pedal to ensure an appropriate vehicle-to-vehicle distance.
SWITCHING TO CONSTANT SPEED (CRUISE) CONTROL MODE
Press and hold the cruise control main switch “ ” for at least 1.5 seconds to turn
on constant speed cruise control. If you are already using DRCC, press the cruise
control main switch “
” to turn DRCC off before activating constant speed cruise
control.
Note: When the vehicle is turned off, it will automatically default to DRCC.
SETTING CONSTANT SPEED (CRUISE) CONTROL
To adjust speed or cancel, see steps (2) and (3) of ADJUSTING SET VEHICLE
SPEED on page 56.
Refer to the Toyota “Owner’s Manual” for additional information on DRCC operation,
settings adjustments, limitations, and precautions before attempting to use it.
1.5 seconds
Set
MY23_RAV4-PRIME_QRG_V2_ML_0907_PRINT.indd 58 9/13/22 11:46 AM
To Next Page
Loading...
