Router Physical Setup
1. Connect the modem (BTU/ONT) to the router’s WAN port (Blue Color) with an Ethernet cable.
2. Turn on the modem (BTU/ONT), and then wait about 2 minutes for it to restart.
3. Connect the power adapter to the router and turn on the router.
4. Verify that the hardware connection is correct by checking the following LEDs.
Note:
Note: If the 2.4GHz LED and 5GHz LED are off, press and hold the WPS/Wi-Fi button on the back for more than 2 seconds, then release
the button. Both the LEDs should turn solid on.
To Next Page
Loading...
