Connect the Hardware
Modem
Power adapter
Router
Power adapter
Connect the power adapter
to the router and turn on
the router.
5
Internet
Quick Installation Guide
AC1900 Wireless Dual Band Gigabit Router
Turn on the modem and
then wait about 2 minutes
for it to restart.
Connect the modem to the
Internet port on your router
with an Ethernet cable.
Confirm that the following LEDs are
on and solid to verify the hardware
connection is correct.
Turn off the modem,
and remove the backup
battery if it has one.
2
4
3
6
Power
On
On
Internet
5G
On
2.4G
On
1 Install the antennas.
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router’s Internet port, and then follow Step 1, 5 and 6
to complete the hardware connection.
Note: If the 2.4G LED and 5G LED are
off, please press the WiFi button on the
side panel for 2 seconds and both the
LEDs should turn solid on in a few seconds.
C9
To Next Page
Need help?
General
Weight and Dimensions
