Archer D7 AC1750 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
63
Click on the Refresh button to update this page.
4.10 Guest Network
There are four submenus under the Guest Network menu: Basic Settings 2.4GHz, Basic
Settings 5GHz, Guest Status 2.4GHz and Guest Status 5GHz. Click any of them, and you will
be able to scan or configure the corresponding function. The detailed explanations for each
submenu are provided below.
4.10.1 Basic Settings 2.4GHz
Choose menu “Guest Network”“Basic Settings 2.4GHz”, and you will see the screen as
shown in Figure 4-51. This feature allows you to create a separate network for your guest
s without
allowing them to access your main network and the computers connected to
it.
Figure 4-51
You can enable or disable Guest Network. When you enable this function, you could set wireless
parameters for Guest Network.
SSID: The guest network name. When setting up a Guest network, it is strongly
recommended to use a name that easily distinguishes it from your primary network. The
default name is TP-LINK Guestxx (xx is the last two numbers of MAC address).
Security: The default value is disabled, but it’s strongly recommended to enable
To Next Page
Loading...
