3. Follow the step-by-step instructions to set up the internet connection and register for the TP-Link Cloud service.
LED & Button Explanation
Pulsing Orange
The system is starting up.
Solid White
The router is working normally.
Solid Red
No internet connection.
Pulsing Red
The Wi-Fi is off and there is no internet connection.
Solid Orange
The router is connected to the internet, but the Wi-Fi is off.
Pulsing White
The firmware is being upgraded, WPS connection is being established or the router is
being reset.
WPS Button
Press the WPS button, and immediately press the WPS button on your
client to start the WPS process.
Wi-Fi button
Press the Wi-Fi button for at least 2 seconds to turn on or off the
wireless function of your router.
LED button
Press the LED button to turn on or off the LEDs of your router.
Keep the device away from water, fire, humidity, or hot environments.
Do not attempt to disassemble, repair, or modify the device. If you need
service, please contact us.
Do not use any other chargers other than those recommended.
Do not use a damaged charger or USB cable to charge the device.
Do not use the device where wireless devices are not allowed.
The adapter shall be installed near the equipment and shall be easily accessible.
For technical support, replacement services, the user guide and more information, please
visit https://www.tp-ink.com/support
To Next Page
Loading...
