Please note: There are multiple versions of this modem, and these are the instructions for one of the
versions. Further information and manual can be found at this address:
https://static.tp-link.com/2019/201907/20190731/1910020873_Archer%C2%A0VR1600v(AU)_UG_V1.0.1.pdf
Step 1
Connect your nbn™ equipment and modem using the setup guide provided for your technology type.
If you have not completed this, please refer back to the first set up guide.
Step 2
Ensure the modem is powered on. Using a pin, reset the modem by pressing and holding the reset
button on the modem until all the lights go off.
Step 3
Using your own device (computer, laptop, tablet or smartphone), connect to the modem using one of
the two options shown below: Ethernet cable directly to the Ethernet port or WiFi.
Ethernet
Connect the Ethernet cable (this is usually yellow, blue, grey or white) as shown below from the
Ethernet port (LAN port) on the modem to the Ethernet port on your computer or laptop.
WiFi
To Next Page
Need help?
General
