8
Option 2: Wall Mounting
Step 4:
Connect the antennas to the EAP.
Step 1:
Place the mounting bracket in the
position you require. Mark three
positions for the screw holes .
Drill three 6mm (in diameter) holes
at the marked positions.
Step 2:
Insert the plastic wall anchors into
the 6mm holes. Align the bracket
to the plastic wall anchors and
drive the self-tapping screws into
the anchors through the bracket.
Step 3:
Align the mounting tabs on the
back of the EAP with the four slots
of the mounting bracket. Push and
slide the EAP downward until it
locks into place.
To Next Page
Loading...
