2
English
2
Place the mounting bracket in the center of the ceiling tile.
Mark positions for the screw holes and a position for the
Ethernet cable hole. Drill holes for the screws and a hole for
the Ethernet cable at the marked positions.
Hole for Ethernet cable
3
Secure the mounting bracket to the ceiling tile using pan-head
screws, washers and wing nuts.
4
Feed the Ethernet cable through the hole and set the ceiling
tile back into place.
5
Connect the Ethernet cable to the Ethernet port. Attach the
AP to the mounting bracket by aligning the arrow mark on the
AP with the arrow mark on the mounting bracket, then rotate
the AP until it is locked into place.
■ Option 2: Wall Mounting
Follow the steps below to install the AP with the provided accessories:
Note: The mounting bracket and the accessories (quantity and size) may vary by product.
Plastic Wall Anchors Self-tapping Screws
To Next Page
Loading...
Need help?
General
