TP-Link CPE710 - Page 67

63
Connection
Mode
Select the Connection Mode.
• 2Q'HPDQG
Configure the device to disconnect your internet connection after a
specified period of inactivity (Idle Time). If your internet connection
has been terminated due to inactivity, Connection on Demand enables
the device to automatically re-establish your connection when you
attempt to access the internet again. The default Idle Time is 15
minutes. If your internet connection is expected to remain active all the
time, enter 0 in the Idle Time field. If you pay by time for your internet
access, choose this mode to save your internet-access fee.
• $XWRPDWLF
Connect automatically after the device is disconnected. If you are
charged a flat monthly fee, choose this mode.
• 0DQXDO
Configure the device to make it connect or disconnect manually. After
a specified period of inactivity (Idle Time), the device will disconnect
your internet connection, and you must click
Connect manually to
access the internet again. If your internet connection is expected to
remain active all the times, enter 0 in the Idle Time field. Otherwise,
enter the desired Idle Time in minutes you wish to use. If you pay by
time for your internet access, choose this mode to save your internet-
access fee.
Second
Connection
If your ISP provides a Connection type such as Dynamic/Static IP to
connect to a local area network, activate this secondary connection.
'\QDPLF,3 Use dynamic IP address to connect to the local area
network provided by ISP.
6WDWLF,3 Use static IP address to connect to the local area network
provided by ISP.