Smart
Wi-Fi
Light
Switch
-
0
Blinking Amber and Green: App-Conf1g mode initiated.
Green: Lit up
for
about 30 seconds when successfully
connected
to
the Wi-Fi network, then
turns
off
.
Blinking Amber: Resetting.
I
"2
I
I
Red:
No
Wi-Fi connection.
,,
'J
0
0
White: Lit up when the
light
is switched
OFF
to
show the
Smart Switch location in the dark.
I
RE
s
TART
I Press
to
reboot the Smart Switch.
I
RE
s
ET
I Press and hold (about 5 seconds) until the Wi-Fi status
LED
blinks amber and green alternately
to
initiate App-Conf1g
mode.
Press and hold (about
10 seconds) until the Wi-Fi status
LED
blinks amber rapidly
to
factory
reset the Smart Switch.
Troubleshooting
1.
What should I do when I can't turn the Smart Switch
on/off
manually?
If
the Smart Switch
doesn't
respond when pressing the physical switch:
• Make sure
that
you restore power
to
the
Smart Switch at the circuit breaker.
Make sure the Smart Switch is wired correctly. Please
consult
with a qualified
electrician.
2.
What should I do when the Smart Switch doesn't respond to commands or
scheduled automations?
Check your
network
connectivity
.
Check
if
the Wi-Fi status
LED
on the
Smart
Switch is blinking amber and
green.
If
so, reconnect the Smart Switch
to
your Wi-Fi network.
Do
not
use a metal faceplate
with
the Smart Switch
to
prevent Wi-Fi signal
interference.
Power cycle
your
router
and/or
reboot the Smart Switch by pressing the
RESTART
button
underneath the
switch
.
Factory reset the Smart Switch by pressing and holding the
RESET
button
.
You'll need to configure the Smart Switch again.
3. How do I pair the Smart Switch with Amazon Echo?
Visit
www
. tp-link.com/en/ faq-944.
html
or
within
the Kasa Help section for
pairing
instructions
.
Suo
ort
If
you encounter any issues during installation
or
configuration, please
visit
for web
support
and troubleshooting information.
© 2016
TP
-L
1nk.
All rights
re
serv
ed.
To Next Page
Loading...
