How to perform a Ping test on TP-Link JetStream T1500-28PCT?
To perform a Ping test on your TP-Link Switch, navigate to MAINTENANCE > Network Diagnostics > Ping. In the Ping Config section, enter the destination device's IP address, and configure the Ping times, data size, and interval as needed. Click Ping to initiate the test. The results will be displayed in the Ping Result section.
How to perform a Tracert test on TP-Link Switch?
To perform a Tracert test on your TP-Link Switch, go to MAINTENANCE > Network Diagnostics > Tracert. In the Tracert Config section, enter the destination IP address and set the maximum hop count. Then, click Tracert to begin the test.
General| PoE Ports | 24 |
|---|---|
| Total PoE Power Budget | 192W |
| Switching Capacity | 56 Gbps |
| Layer | Layer 2 |
| MAC Address Table | 8K |
| Operating Humidity | 10% to 90% non-condensing |
| Storage Humidity | 5% to 90% non-condensing |
| Dimensions | 440 x 180 x 44 mm (17.3 x 7.1 x 1.7 in) |
| Standards and Protocols | IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3af, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p |
| Jumbo Frame | 9K |
| Power Supply | Internal |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Forwarding Rate | 41.66 Mpps |
To Next Page
