Quick Installation Guide
Wireless 4G LTE Router
1. Connect the Hardware
Images may dier from actual products.
©2022 TP-Link 7106509950 REV1.1.0
Check the following LEDs’ status. If the Internet LED is on, your router is connected
to the internet successfully.
3. Enjoy the Internet2. Verify the Hardware Connection
Note: If the Internet LED does not turn on, please refer to Q2 of Need Help in this guide.
Power
On
On
Internet
On
Wi-Fi
For better internet connection, make sure 2 or 3 bars of the Signal Strength LED
are lit. Otherwise, try relocating the router to a spot that may receive a stronger mobile
network signal, such as near a window.
Wireless
Wired
Connect your computers to the router's LAN ports via Ethernet cables.
Find the SSIDs (network names) and wireless password printed on the label at the
bottom of the router.
a.
Click the network icon of your computer or go to Wi-Fi settings of your smart device,
and then select the SSID to join the network.
b.
Wireless Password/PIN:XXXXXXXXX
SSID:TP-Link_XXXX
SSID:TP-Link_XXXX_5G
c. Connect the
power adapter
and turn on the
router.
b. With the gold contacts
facing down, insert the
nano SIM card into the
slot until you hear a
click.
Power adapter
a. Install the antennas
and position them
upwards.
To Next Page
Need help?
General
