Check the following LEDs’ status. If the Internet LED is on, your router is
connected to the internet successfully.
Quick Installation Guide
Wireless 4G LTE Router
1. Connect the Hardware
3. Enjoy the Internet2. Verify the Hardware Connection
Images may dier from actual products.
Note: If the Internet LED does not turn on, please refer to Q2 of Need Help? in this guide.
Power
On On
Internet
On
Wi-Fi
For better internet connection, make sure 2 or 3 bars of the Signal Strength LED
are lit. Otherwise, try relocating the router to a spot that may receive a stronger mobile
network signal, such as near a window.
Wired
Wireless
Connect your computer to the router's LAN port via an Ethernet cable.
©2019 TP-Link 7106508509 REV1.0.0
Find the default SSID (network name)
and wireless password printed on the
label at the bottom of the router.
a.
Click the network icon of your computer or go to Wi-Fi settings of your smart device,
and then select the SSID to join the network.
b.
300Mbps Wireless N 4G LTE Router
Model: TL-MR100
S/N:XXXXXXXXXXXXX EU/1.0
IMEI:XXXXXXXXXXXXXXX
Power: 9V 0.85A
Default Access:
http://tplinkmodem.net
TP-Link Technologies Co., Ltd.
No.5 Keyuan Road, Nanshan, Shenzhen, 518057, PRC
SSID:TP-Link_XXXX
MAC:XX-XX-XX-XX-XX-XX
Wireless Password/PIN: XXXXXXXX
SSID:TP-Link_XXXX
MAC:XX-XX-XX-XX-XX-XX
Wireless Password/PIN: XXXXXXXX
SIM card requirement
!
Micro SIM card
Nano SIM card + Provided SIM card adapter + Provided sticker
+ +
Standard
SIM card
c. Connect the
power adapter
to the router.
b. Insert the Micro SIM card
into the slot until you
hear a click.
Power adapter
Router
a. Install the antennas and
position them upwards.