17
Chapter 3 Customize Your Network
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with the password you set for the extender.
2. Go to Settings > Network.
3. Select Use the following IP address.
4. Enter a new IP address as needed and leave the Subnet Mask as the default settings.
5. Enter the gateway that is in the same subnet as the IP Address. The gateway is usually
the LAN IP address of your extender.
6. Leave the primary and secondary DNS addresses as the default settings.
7. Click SAVE .
3. 4. Adjust Wi-Fi Coverage
You can set the extender’s Wi-Fi coverage depending on how large you want your Wi-Fi
area to be.
1. Visit http://tplinkrepeater.net, and log in with the password you set for the extender.
2. Go to Settings > Advanced Settings > Wi-Fi Coverage.
3. Select Maximum Coverage, Intermediate Coverage or Minimum Coverage to adjust
your Wi-Fi coverage of the extender.
To Next Page
Loading...
