4
Chapter 1
Get to Know About Your Extender
1. 2. 1. LED Explanation
You can check the extender’s working status by following the LED Explanation table.
Name Status Indication
(Signal)
Solid blue
The extender is connected to your router’s wireless network
and is in a suitable location.
Solid red
The extender is experiencing poor signal strength. Try
relocating it closer to your router.
Flashing blue WPS connection is being established.
Off No wireless connection is established.
2.4GHz/5GHz
On
The extender is connected to the 2.4GHz/5GHz wireless
network of your host router.
Off No wireless connection has been established.
Power
On The extender is on.
Flashing The extender is starting up.
Off The extender is off.
Ethernet
On A powered-on device is connected to the Ethernet port.
Off No powered-on device is connected to the Ethernet port.
1. 2. 2. Port and Button Description
Ports or Buttons Description
WPS Button
Press the WPS button on your host router, and immediately press the WPS
button on the extender. The Signal LED of the extender should change to
solid blue, indicating successful WPS connection.
Power Button Press the Power button to turn on or off the extender.
LED Button Press the LED button to turn on or off all the LEDs.
Reset (Hole)
Use a pin to press and hold the Reset button until all the LEDs turn on
momentarily to reset the extender.
Ethernet Port
Connect your Ethernet-only device to the Ethernet port of the extender to join
the Wi-Fi network.
To Next Page
Loading...
Need help?
General
