TP-Link tapo S505D - Page 8

6
Step 1. Turn O Power and Remove the Wallplate
Turn o the circuit breaker. Then remove the old wallplate of the wall
switch and label the wires.
Step 3. Identify Line and Load wires
1) Turn on the circuit breaker. Use a voltage detector to identify the
energized wire (Line wire).
Wire Your Switch
Step 2. Expose Your Switch Wiring
Remove the screws securing your old switch to the wall box. Gently
pull the switch out and disconnect wires from the old switch.
2) Turn o the circuit breaker. Label the Line and Load wires.
Load wire
Line wire
MISE EN GARDE
Risque d'électrocution - Haute tension. Débrancher l'alimentation électrique avant d'utiliser.
CAUTION
Risk of Electric Shocks - High Voltage - Disconnect power supply before servicing.