2
Power on all your network devices and then check to see if the LEDs of the
Router display normally as the diagram below describes.
Note
If the LEDs display abnormally, please check to see if all the cable
connectors (power adapter, phone line and Ethernet cable) are well
connected to your device. With the phone line well connected, if the ADSL
LED turns off after flashing, please contact your ISP to ensure that you
internet connection is active.
To configure the device, you can either run the setup CD-ROM (method
one), or run the Web based Quick Setup Wizard (method two). TP-LINK
strongly recommends that you run the setup CD-ROM.
Note
Solid light
Solid light if the LAN
port is connected
Solid light or flashing
Solid light or flashing
To Next Page
Loading...
