Server IP:
Enter the Server IP provided by your ISP.
MTU:
MTU (Maximum Transmission Unit) is the maximum data unit
transmitted by the physical network. It can be set in the range of
576-1460. The default MTU is 1460. It is recommended to keep the
default value if no other MTU value is provided by your ISP.
Active Mode:
You can select the proper Active mode according to your need.
Manual: Select this option to manually activate or terminate the
Internet connection by the <Connect> or <Disconnect> button.
It’s optimum for the dial-up connection charged on time.
Always-on: Select this option to keep the connection always on.
The connection can be re-established automatically when it is
down.
Secondary
Connection:
Here allows you to configure the secondary connection. Dynamic IP
and Static IP connection types are provided.
Connection Type:
Select the secondary connection type. Options include Disable,
Dynamic IP and Static IP.
IP Address:
If Static IP is selected, configure the IP address of WAN port. If
Dynamic IP is selected, the IP add
ress of WAN port obtained is
If Static IP is selected, configure the subnet mask of WAN port. If
Dynamic IP is select, the subnet mask of WAN port obtained is
displayed.
Default Gateway:
If Static IP is selected, configure the default gateway. If Dynamic IP is
selected, the obtained default gateway is displayed.
Primary DNS/
Secondary DNS:
If Static IP is selected, configure the DNS. If Dynamic IP is selected,
the obtained DNS is displayed.
Upstream Bandwidth:
Specify the bandwidth for transmitting packets on the port.
Downstream
Bandwidth:
Specify the bandwidth for receiving packets on the port.
-24-
To Next Page
Loading...
